ARM and RISC basics and difference between ARM and RISC

This ARM tutorial covers ARM and RISC basics and difference between ARM and RISC. Refer following pages for other ARM tutorial contents.

ARM History and Introduction

• ARM stands for Advanced RISC Machine.
• First developed at Acron Computer Limited of Cambridge between 1983 & 1985.
• ARM Limited formed in 1990.
• Industry's leading producer of 16/32 embedded RISC machine.
• Licenses its core designs to semiconductors and does not make ICs.

• Based on RISC architecture
• High code density, low power consumption & low silicon area
• It is a load-store architecture, data processing through registers and does not involve changes directly within memory
• Good speed vs power consumption ratio

RISC features

Instructions: Lower number of instructions compared to CISC. The compiler or programmer synthesizes complicated operations (for example, a divide operation)by combining several simple instructions. Each instruction is a fixed length to allow the pipeline to fetch future instructions before decoding the current instruction.

Pipeline: The processing of instructions is broken down into smaller units that can be executed in parallel by pipelines. Ideally the pipeline advances by one step on each cycle for maximum throughput. Instructions can be decoded in one pipeline stage. There is no need for an instruction to be executed by a miniprogram called microcode as on CISC processors.

Fixed number of instruction cycles: Most instructions single cycle.

Registers: RISC have a large number of general purpose registers while CISC have special purpose registers. In RISC any register can contain either data or an address. Registers act as the fast local memory store for all data processing operations.

Load-store architecture -The processor operates on data held in registers. Separate load and store instructions transfer data between the register bank and external memory. Memory accesses are costly, so separating memory accesses from data processing pro-vides an advantage because you can use data items held in the register bank multiple times without needing multiple memory accesses. In contrast, with a CISC design the data processing operations can act on memory directly.

ARM feature improvements over RISC

Variable cycle execution for certain instructions-Not every ARM instruction executes in a single cycle. For example, load-store-multiple instructions vary in the number of execution cycles depending upon the number of registers being transferred. The transfer can occur on sequential memory addresses, which increases performance since sequential memory accesses are often faster than random accesses.

Inline barrel shifter leading to more complex instructions-The inline barrel shifter is a hardware component that preprocesses one of the input registers before it is used by an instruction. This expands the capability of many instructions to improve core performance and code density.

ARM has enhanced the processor core by adding a second 16 bit instruction set called Thumb. This thumb instruction permits the ARM core to execute either 16 bit or 32 bit instructions. The 16 bit instructions improve code density by about 30 percent compare to 32 bit instructions of fixed length.

Conditional execution-An instruction is only executed when a specific condition has been satisfied. This feature improves performance and code density by reducing branch instructions.

Enhanced instructions-The enhanced digital signal processor (DSP) instructions were added to the standard ARM instruction set to support fast 16 x 16-bit multiplier operations and saturation. These instructions allow a faster-performing ARM processor in some cases to replace the traditional combinations of a processor plus a DSP.

ARM Profiles

ARM Profiles are A Profile,M Profile and R Profile.

Similar posts on ARM

ARM tutorial page1
ARM tutorial page2
ARM tutorial page3
ARM tutorial page4
ARM tutorial page5
ARM tutorial page6